Multi-Beam Couplings | Huco Dynatork

These general purpose, multi-beam couplings will readily accommodate any combination of axial motion and angular & parallel misalignment but should be used with caution if low bearing loads are desirable. The three start helical-cut design provides higher torque capability and greatly reduced wind-up when compared to single beam couplings. The 6 beam version provides greater misalignment capability but reduced torque accuracy when compared to the 3 beam version.

Product Features

  • Material Options: Aluminium, Stainless Steel, Acetal
  • Speeds: Up to 5000 rpm
  • Peak Torque Largest Size lbs.-in (Nm): 1239(140) 
  • Standard Bores in. (mm): 1/8" -1 1/4" (1 to 38) 
  • Temperature: -40° to +290°F , (-40° to +140°C)
  • Electrically Isolating: Aluminium & Stainless Steel No , Acetal Yes
  • Connection: Clamp or Set Screw
  • Torsionally rigid design
  • Zero backlash
  • No moving parts
  • Single beam simple coupling compatible with industry standard types
  • 3-Beam single stage for increased torsional stiffness
  • 6-Beam two stage for torsional stiffness and increased radial compliance
  • Step Beam for low inertia, electrical isolation, low cost

Product Data Sheets


Click on image below to download pdf. To order hard copies of literature click here.

Product Catalog

(A4) Flexible Couplings Flexible Couplings

Related Literature

Huco Dynatork Line Card Flexible Couplings Overview

Contact Info

Merchant Drive, Hertford
Hertfordshire, SG13 7BL – England
Phone: +44(0)1992 501900
Fax: +44 (0)1992 509890