UpComing Tradeshows

February 07-09, 2017
West Pack Expo 2017
Anaheim, CA

February 08-10, 2017
INDUMATION 2017
Harelbeke, Belgium

February 19-22, 2017
SME 2017
Denver, CO

Back To Newsroom

Ameridrives Modified Americardan 3285 Universal Joints for Steel Mill Slab Caster

Molten Steel Ladle

The original U-joints installed in this demanding application featured split-flanged yokes. The driven (segment) ends of the U-joints pass through the sidewall of the segment frame and position within 12" of a heat/water wall. The tight space constraints did not allow full access to the roller end of the U-joints. This resulted in mounting bolts that could not be tightened to the torque specifications.

Over time, the loose bolt connections between the spool and split-flange yokem (driven end) allowed the key to shift, causing the keyway and holes to become elongated in the mated flanges. This caused premature wear on the segment rollers, segment bearings, and flange yokes, resulting in uneven torque loads being transferred to other drives which over-torqued the next immediate segment, eventually causing the cross to fail within the flange yoke assembly. In some cases, slabs would have to be stopped inside the caster which required them to be cut out.

Ameridrives engineers' extensive U-joint experience with steel mill applications allowed them to develop a creative new facing connection that solved the customer’s dilemma. The solution was an integral tapered key or face pad design for the roller end of the U-joints to replace the straight face key flange yokes. The new face pad configuration featured four raised, wedge-shaped integral keys and required only four mounting bolts versus the typical eight-bolt design. With the enhanced reliability of the new U-joint modification, the customer's up-time increased and slab quality was improved.

Americardan 3285 U Joint

Highlights

  • Integral tapered key or face pad developed for roller ends of U-joints
  • U-joints compensate for approximately 10-degree angular misalignment and shock loads of up to 800,000 in. lb. torque
  • Tapered key allows for easier, more reliable connection of U-joints to segment roll spools
  • Mill rotation speed: 8 RPM (5ft./min.)
  • 11 pairs of U-joints were modified

Contact Information

1680 Cornell Rd.
Green Bay, WI 54313
Phone: 1-920-593-2444
Email: info@ameridrives.com
www.ameridrivespowertransmission.com