UpComing Tradeshows

April 22-27, 2017
ISRI 2017
New Orleans, LA

April 23-26, 2017
GCA 2017
Galveston, TX

April 24-28, 2017
Hannover Messe 2017
Hannover, Germany

Back To Newsroom

Matrix International 1CD Series Brake for Bakery Dough Lift

Bakery Dough Lift

When a competitor’s gearbox failed on a dough lifting system at a Chicago area commercial bakery, the bin transporting 1500 pounds of raw bakery dough dropped more than a dozen feet in an instant. While no one was injured in the incident it was clear that a potential hazard existed.

In the system a gearmotor with hollow shaft output drives the lift mechanism. Since the concern was that another gearing failure would lead to loss of control of the load, a gearmotor with an integrated brake was not the answer; the brake had to be external to the gearmotor.

The bakery contacted Altra Industrial Motion for assistance with selecting the best brake solution for the application. The brake would have to stop and hold the 1500 lb. load in the event the gearmotor output gears were to fail again. Several possible Altra braking choices were reviewed. Ultimately, it was determined that a Matrix 1CD Series brake was the most adaptable
and economic solution to meet the challenge.

The electrically-released, spring-set 1CD brake mounts as a caliper and clamps to both sides of a flat disc. The Model 1CD070 provides 3300 N (741 lbs.) of clamping force. To accommodate the brake, an extended shaft was included that engages the lifting mechanism and provides a mounting surface for the brake. The application required 944 ft. lbs. of torque to stop and hold the load. The brake was sized so that it could provide the same torque as the acceleration torque of the gear motor. A single 1CD070 module could be used with a 32 in. diameter disc or a pair of 1CD070s could be used with a 16 in. disc. This application highlights the flexibility of the 1CD series. By changing the friction disc diameter, the torque capacity of the brake can be increased or decreased.

Matrix International CD1 Brake

Highlights

  • Electrically-released, spring-set brake mounts as a caliper and clamps to both sides of a flat disc
  • 3300 N (741 lbs.) of clamping force
  • Brake sized to provide the same torque as the acceleration torque of the gear motor
  • An extended shaft was also provided

    Contact Information

    East Mill Road
    Brechin, Angus, DD9 7EP – Scotland
    Phone: +44 (0) 1356 602000
    Email: sales@matrix-international.com
    www.matrix-international.com