Back To Newsroom
Wichita Clutch ModEvo Tension Brake for Thin Gauge Steel Coating Line
The challenge at a regional window treatment company was to ensure a consistent, even spray
of the final coating on the steel material used in their manufacturing process. The steel unwinds
from a coil and passes through multiple coating baths then through an oven. The coated steel is
then buffed to a smooth finish followed by a final coating application. A consistent tension on the
steel web is required to ensure that the final coating is uniformly applied.
The steel material moves at 300 FPM through a set of 24” diameter nip rollers positioned just ahead
of the final coating applicator. A brake is required at the nip rollers to provide consistent pace, applying
the 500 lbs. of tension across the total web width to ensure final coating application consistency.
Wichita Clutch application engineers determined that the nip rollers would have a rotational
speed of 48 RPM while the brake will require 500 ft.lbs. of torque capacity and need to dissipate
heat of up to 2.4 thermal HP.
Wichita’s ModEvo size 300/4 brake was the ideal choice to provide the necessary torque and
heat dissipation for this unwind application. The brake has a 557 ft.lb. torque capacity and a
6.71 thermal HP heat capacity when used with an optional fan. The ModEvo modular design will
allow the customer to increase torque capacity or line speed at a later date by simply adding an
additional set of air actuator modules. Conversely, if they need to reduce the size of the web to
the point where the brake might be oversized, they can easily disconnect one of the modules
from the air source to downsize the brake.
The brake is controlled via an electric-to-pneumatic transducer that varies air pressure to the
brake based on a 0-10 volt analog signal from the customer’s PLC control.
- ModEvo 300/4 brake
with 557 ft.lb. torque capacity
- 6.71 thermal HP heat
- Unique modular design
provides tension control
- Optional cooling fan
available for extreme heat
- Three actuator options are
available with clamping
forces of 100%, 60%
- Standard and low friction
coefficients pad options